Twist on BNC Connector
1. Trim Cable as shown. Taking care not to nick the center conductor or outer braid.
2. Twist the outer braid in a clockwise direction in such a manner that at least 1/32 of inner dielectirc is bared, and the braid is left flat. (stray or loose braid can cause shorts)
3. Gently insert the center conductor down into the back end of the connector, feeling it into the guide hole. When the center conductor is not in place approx 1/8" of center conductor will show.
4. Firmly push the cable home as far as possible. Then screw the connector on the cable in a clockwise direction until it stops.
2 Piece BNC Connector
1. Run crimp sleeve down cable.
2. Trim the cable as shown. Taking care not to nick the center conductor or outer braid.
3. Insert center conductor into the guide hole. In the rear of the connector, and firmly push the cable home.
4. Push crimp sleeve into place. Sandwiching the brain between the connector and sleeve.
5. Crimp the sleeve into place with the proper crimp tool.
3 Piece BNC Connector
1. Trim the cable as shown. Taking care not to nick the center conductor or outer braid.
2. Slip crimp sleeve over cable. Place inner conductor into the contact. Note that the end of the contact and inner dielectric must be butting and square. Crimp with proper crimp tooling.
3. Flair outer braid, and gently but firmly push the contact into the connector housing until a gentle snap is felt. Indicating the contact is in place. Slip the crimp sleeve in place, butting the flange against the connector body and crimp with proper tooling.
Cable Stripping Instructions
| - RG59/U Plenum RCA - RG6/U Plenum & RG6Q.S Plenum BNC - RG59/U Plenum & RG59Q.S Plenum BNC - RG6/U (RG6 Quad) BNC, BNC Ra, BNC Jack - RG59/U BNC, BNC RA, BNC Jack |
- RG6/U Plenum RCA (RCA Jack) - RG6/U Quad, RG6/U Quad RCA RA - RG6/U Quad RCA Jack - RG59/U RCA, RCA RA, RCA Jack |
 |
 |
All "F" Type Compression Connectors
Notes: By slitting the jacket 3-4mm will help in pushing the connector onto the coaxial cable. Mark the coaxial jacket either at the 31m or the 35mm length.
Mark the jacket 31mm or 35mm from the end of the conductor.